Hyundai Kona: Exterior lights / Front fog lamp
.png)
Fog lamps are used to provide improved visibility when visibility is poor due to fog, rain or snow, etc.
Use the switch next to the headlamp switch to turn the fog lamps ON and OFF.
1. Turn on the position lamp.
2. Turn the light switch (1) to the front fog lamp position.
3. To turn off the front fog lamp, turn the light switch to the front fog lamp position again or turn off the position lamp.
NOTICE
When in operation, the fog lamps consume large amounts of vehicle electrical power. Only use the fog lamps when visibility is poor.
Turn signals and lane change signals
To signal a turn, push down on the lever for a left turn or up for a right turn
in position (A). To signal a lane change, move the turn signal lever slightly and
hold it in position (B).The lever w ...
Rear fog lamp
Vehicle with front fog lamp
To turn on the rear fog lamp:
Position the light switch in the position lamp position, turn the light switch
(1) to the front fog lamp position, and then turn the light s ...
Other information:
Hyundai Kona (OS) 2018-2024 Service Manual: Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (A) on the bottom of the condenser with a L wrench.
Tightening torque :
9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7 ...
Hyundai Kona (OS) 2018-2024 Owners Manual: Malfunction Indicator Lamp (MIL)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to the
ON position. - It illuminates for approximately 3 seconds and then goes off.
When there is a malfunction with the emission control system. In this
case, we recommend that you have the vehi ...
