Hyundai Kona: ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor Repair procedures

Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of vacuum hose.
2.
Connect GDS to DLC (Data Link Cable).
3.
Warm up the engine to normal operating temperature.
4.
Monitor "BBVPS" parameter on GDS.
Brake Booster Vacuum Pressure Sensor Schematic diagrams
Circuit Diagram ...

AGM Battery Description and operation
Description [AGM Battery for ISG System] AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent G ...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: Water Temperature Control Assembly Repair procedures
Removal and Installation 1. Disconnect the battery "-" terminal. 2. Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover") 3. Remove the engine room unde ...

Hyundai Kona (OS) 2018-2025 Service Manual: Repair procedures
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt. 2. Adjust the hood height by moving the hood overslam bumpers (C) up and down. ...

© 2018-2025 www.hkona.com