Hyundai Kona: ISG (Idle Stop & Go) System / AGM Battery Description and operation

Hyundai Kona (OS) 2018-2025 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / AGM Battery Description and operation

Description

[AGM Battery for ISG System]

AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fleece. AGM batteries are fitted in models with electrical loads/consumers which have a high energy demand.

The constantly increasing energy demand of modern vehicle electrical systems calls for ever more powerful battery solutions.

The power consumption is considerable even when the vehicle is parked.

The somewhat higher price compared with a battery of similar size is fully balanced by the following benefits :

–	Significantly longer service life

–	Increased starting reliability at low temperatures

–	100 % freedom from maintenance

–	Low risk in event of an accident (reduced risk to the environment)

Check the battery condition

The battery condition cannot be determined solely on the basis of the battery charge state. If there is a suspicion of a damaged battery, check the battery condition whit battery tester and investigate the cause by means of the test module. With a low battery charge state, recharge the battery.

Recharging the AGM battery

The battery may be charged using the battery chargers at a constant charge voltage of 14.8V.

If possible, the battery temperature during charging should be between 20°C (68°F) and 30°C (86°F).

Only chargers with voltage clamping (IU or WU curve) may be used or chargers with IUoU curve which have a trickle.

IU or WU charging technique

Optimized charging voltage for IU or WU : 14.7V (at 20°C - 30°C (68°F - 86°F)) about 24 hours

Min. charging voltage at 20°C (68°F) : 14.4V

Max. charging voltage at 20°C (68°F) : 14.8V

10% of capacity is recommended as charging current (e.g. 60Ah : 10 = 6,0A charging current).

•	Do not charge the AGM battery with>15.2V. No quick-charging routines.

•

If the battery is charged directly at the battery terminals on vehicles with battery sensor, misinterpretations of battery condition and under certain circumstances also unwanted Check Control messages or fault memory entire can occur.

After recharging finished, let the battery stand for over 10 hours with normal temperature for battery stabilization.

Brake Booster Vacuum Pressure Sensor Repair procedures

Inspection 1. Check installation status of BBVPS and Vacuum hose or damage of vacuum hose. 2. Connect GDS to DLC (Data Link Cable). ...

AGM Battery Specifications

Specifications ▷AGM60L-DIN Item Specification Model type AGM60L-DIN Capacity [20HR/5HR] (AH) 60/ ...

Other information:

Hyundai Kona (OS) 2018-2025 Owners Manual: With the central door lock/unlock switch
When pressing the () portion (2) of the switch, all vehicle doors will lock. If any door is opened, the doors will not lock even though the lock button (2) of the central door lock switch is pressed. If the smart key is in the vehicle and any door is opened, the doors will not lock even tho ...

Hyundai Kona (OS) 2018-2025 Service Manual: Rear Seat Back Cover Components and components location
Component Location 1. Rear seat back cover [LH] 2. Rear seat back cover [RH] ...