Hyundai Kona: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Hyundai Kona (OS) 2018-2024 Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check signal waveform of CKPS and CMPS using a GDS.

Specification : Refer to "Waveform"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A).

3.	Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

4.	Remove the crankshaft position sensor (A) after loosning the mounting bolts.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

Install in the reverse order of removal.

Crankshaft position sensor installation bolt :

7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic diagrams

Circuit Diagram Harness Connector ...

Camshaft Position Sensor (CMPS) Description and operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and ...

Other information:

Hyundai Kona (OS) 2018-2024 Service Manual: DC/DC Converter Schematic diagrams
Circuit Diagram [200W] [450W] ...

Hyundai Kona (OS) 2018-2024 Owners Manual: Climate control air filter
Filter inspection If the vehicle is operated in the severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you, the owner, replace the climate control air filter, replace it performing the following procedure, and ...