Hyundai Kona: Cowl Top Cover / Repair procedures

Replacement
1.
Remove the plug hole (A).

2.
Remove the cap and the nuts, and then remove the wiper arm (A).
Tightening torque :
22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)

3.
Using a screwdriver or remover, remove the cowl top side cover (A).

4.
Disconnect the washer nozzle (A).
5.
Detach the clips, then remove the cowl top cover (B).

6.
To install, reverse removal procedure.
  
Replace any damaged clips (or pin-type retainers).
Components and components location
Component Location 1. Cowl top cover ...

Floor Console
...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: Back-up Lamps Repair procedures
Removal LHD 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bubper. (Refer to Body - "Rear Bumper") 3. Loosen the screw and then remove ...

Hyundai Kona (OS) 2018-2025 Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the filling hose (3) of the compressor directly to the tire valve. 3. Plug the compressor power cord into the vehicle power outlet. 4. Adjust the tire inflation pressure to the recomended tire ...

© 2018-2025 www.hkona.com