Hyundai Kona: Rear Seat Belt / Rear Center Seat Belt Retractor Repair procedures

Hyundai Kona (OS) 2018-2025 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Center Seat Belt Retractor Repair procedures

Replacement
  
When installing the belt, make sure not to damage the retractor.
1.
Remove the luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
2.
After loosening the mounting nut, remove the rear center seat belt retractor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

3.
To install, reverse removal procedure.
  
Replace any damaged clips.
Rear Center Seat Belt Retractor Components and components location
Component Location 1. Rear center seat belt retractor ...

Rear Seat Belt Buckle Components and components location
Component Location 1. Rear seat belt buckle [RH] 2. Rear seat belt buckle [LH] 3. Rear center seat belt buckle ...

Other information:

Hyundai Kona (OS) 2018-2025 Service Manual: Troubleshooting
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel bearing Replace ...

Hyundai Kona (OS) 2018-2025 Service Manual: Front Driveshaft Repair procedures
Removal [Gamma 1.6 T-GDI, Nu 2.0 MPI] 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub. Tightenin ...

© 2018-2025 www.hkona.com