Hyundai Kona: Blind-Spot Collision Warning (BCW) / Blind-Spot Collision Warning Indicator Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the mirror (A).
|
| Installation |
| 1. |
Install the outside mirror.
|
| 2. |
Connect the negative (-) battery terminal.
|
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door quadrant inner cover (A).
|
| 3. |
Disconnect the power door mirror connector from the harness.
|
| 4. |
Apply battery voltage to each terminal as shown in the table and
verify that the mirror operates properly.
|
Blind-Spot Collision Warning Indicator Components and components location
Components
1. BCW Indicator
2. Side repeater lamp
...
Other information:
Hyundai Kona (OS) 2018-2024 Service Manual: Ambient Temperature Sensor Repair procedures
Inspection
1.
Check the resistance of the ambient temperature sensor between terminals
1 and 2 whether it changes by changing the ambient temperature.
1. Ambient Sensor
(+)
2. Sensor grou ...
Hyundai Kona (OS) 2018-2024 Service Manual: PTC Heater Repair procedures
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation by confirmation logic as follows;
1.
Entering
(1)
Set the Floor mode and maximum heating position.
(2 ...
