Hyundai Kona: ISG (Idle Stop & Go) System / Alternator Specifications
Hyundai Kona (OS) 2018-2024 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator Specifications
| Specifications |
|
Item |
Specification |
|
Nominal output |
13.5V 130A |
|
Speed in use |
1,000 - 18,000 rpm |
|
Regulator Type |
IC Regulator built in type |
|
ECM Interface type regulator |
LIN communication |
|
Regulated Voltage |
14.2 - 14.8V |
|
Pulley Type |
OAP Pulley |
|
Pin |
1 (COM) |
Alternator Description and operation
Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.In addition, the c ...
Alternator Components and components location
Components
1. Nut
2. Pulley
3. Front housing
4. Front bearing
5. Retainer
6. Rotor
7. Rear bearing
8. Stator
9. Rear housing
10. Regulator
...
Other information:
Hyundai Kona (OS) 2018-2024 Service Manual: Ignition Coil Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).
...
Hyundai Kona (OS) 2018-2024 Service Manual: Oil Cooler Repair procedures
Removal
1.
Loosen the drain plug and drain the coolant. Open the radiator cap to
make rapid draining.
(Refer to Cooling System - "Coolant")
2.
Disconnect the oil cooler hoses (A).
3.
...
© 2018-2024 www.hkona.com
